Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
+ 3.1. Engine OHC
- 3.2. Engine DOHC
3.2.1. A technical characteristics
+ 3.2.2. The repair which is not demanding removal of the engine
- 3.2.3. Removal and installation of the engine without a transmission
3.2.3.1. Engine removal
3.2.3.2. Additional operations on engine removal on cars with АКП
3.2.3.3. Additional operations on removal of the engine from a transmission
3.2.3.4. Engine installation
3.2.3.5. Engine dismantling
3.2.3.6. Cylinders
3.2.3.7. Check and restoration of pistons and piston rings
3.2.3.8. Piston fingers and rods
3.2.3.9. A cranked shaft
3.2.3.10. Radical and шатунные bearings
3.2.3.11. A flywheel
3.2.3.12. Engine assemblage
3.2.3.13. Start of the engine after major repairs
3.2.4. Ventilation system картера
+ 3.2.5. Greasing system
+ 3.3. Engine V6
+ 3.4. Ignition and engine management systems
+ 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment
|
Engine installation is made in sequence, to removal, thus it is necessary to pay attention of return to some features:
– Greasing by oil шлицов a shaft of coupling of a transmission before connection of these knots;
– At coupling installation on a flywheel it is necessary to centre a disk of coupling aligning оправкой;
– If at joining of a transmission to the engine, the primary shaft of a transmission does not enter into a coupling disk it is necessary to turn a cranked shaft of the engine a little;
– To establish a new lining of a forward exhaust pipe;
– To fill system of cooling with a corresponding liquid and to remove air from cooling system;
– To check up and in case of need to adjust a corner of an advancing of ignition, and also number of turns of the engine idling and concentration WITH in exhaust gases. |
|
