Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
+ 3.1. Engine OHC
- 3.2. Engine DOHC
3.2.1. A technical characteristics
+ 3.2.2. The repair which is not demanding removal of the engine
- 3.2.3. Removal and installation of the engine without a transmission
3.2.3.1. Engine removal
3.2.3.2. Additional operations on engine removal on cars with АКП
3.2.3.3. Additional operations on removal of the engine from a transmission
3.2.3.4. Engine installation
3.2.3.5. Engine dismantling
3.2.3.6. Cylinders
3.2.3.7. Check and restoration of pistons and piston rings
3.2.3.8. Piston fingers and rods
3.2.3.9. A cranked shaft
3.2.3.10. Radical and шатунные bearings
3.2.3.11. A flywheel
3.2.3.12. Engine assemblage
3.2.3.13. Start of the engine after major repairs
3.2.4. Ventilation system картера
+ 3.2.5. Greasing system
+ 3.3. Engine V6
+ 3.4. Ignition and engine management systems
+ 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment
|
To check up a flywheel on presence of damages, a flywheel wreath – on presence of deterioration and damages.
If the wreath has strongly worn out or on it there is an absent tooth, it is necessary to replace a wreath. The old wreath can be removed, having made has spent on drink between two teeths, and then to bring down a chisel.
Installation of a new gear wreath on a flywheel demands heating of a wreath to 204 ° S.Eto is carried out by uniform heating of a flywheel by a blowtorch until heated up surfaces will not get a light yellow shade.
The prevention Not to overheat a wreath, differently it прочностные properties will be lost.
The wreath has an oblique inside of teeths which should be turned to a starter. When the wreath will be heated-up enough, quickly to establish it into place, if necessary to tap, and to cool a natural way. |
|
