FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
- 6. Coupling
   6.1. A technical characteristics
   + 6.2. Service and repair
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


b087f616

6. Coupling

6.1. A technical characteristics
THE GENERAL DATA

Coupling is intended for short-term separation of the engine and transmission at a gear change or braking and their smooth connection at трогании the car from a place, and also for protection of details of transmission from dynamic loadings.

Coupling one-disk, dry, constantly closed type, with the central press spring and гасителем крутильных fluctuations on a conducted disk. In картере transmissions the primary shaft of a transmission on which settles down выжимной the bearing which is not demanding maintenance service acts, and outside картера the lever of deenergizing of coupling to which the coupling cable fastens is located.

The principle of action of coupling is based on transfer of a twisting moment from a flywheel and a leading part of coupling on a conducted disk, so, and on a primary shaft of a transmission, at the expense of forces of a friction which arise between disks at the included coupling. At the expense of elasticity of a press spring press the disk clamps in this position among themselves and a flywheel a conducted disk with the effort which is not supposing its proslippings. Thus выжимной the bearing and a press spring do not adjoin.

By pressing a coupling pedal through a cable of coupling and a plug выжимной the bearing presses a press spring of a leading disk of coupling and wrings out a leading disk from a flywheel therefore the conducted disk is released and twisting moment transfer between the engine and a transmission stops.

Free wheeling adjustment – automatic also occurs by means of the ratchet mechanism located about a pedal of coupling.

Key parametres

Mark
Sachs, Automotive Products or Laucock
Nominal course of a pedal of coupling
155 mm
Diameter of a disk of coupling:
  – Engines with working volume 1,8 and 2,0 дм3
216 mm
  – The others
241 mm
Type of frictional overlays on a conducted disk of coupling
Ferodo 3111
Thickness of frictional overlays on a conducted disk of coupling:
  – Engines with working volume 1,8 and 2,0 дм3
3,85 mm
  – The others
3,81 mm
Quantity of springs in a coupling disk:
  – Sachs
6
  – Automotive Products or Laucock
4

The tightening moments

Carter of a transmission to the engine
35 – 45 Nanometers
Leading part of coupling to a flywheel
20 – 25 Nanometers