1985-1994 of release

Repair and car operation

Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   - 3.2. Engine DOHC
      3.2.1. A technical characteristics
      + 3.2.2. The repair which is not demanding removal of the engine
      - 3.2.3. Removal and installation of the engine without a transmission Engine removal Additional operations on engine removal on cars with АКП Additional operations on removal of the engine from a transmission Engine installation Engine dismantling Cylinders Check and restoration of pistons and piston rings Piston fingers and rods A cranked shaft Radical and шатунные bearings A flywheel Engine assemblage Start of the engine after major repairs
      3.2.4. Ventilation system картера
      + 3.2.5. Greasing system
   + 3.3. Engine V6
   + 3.4. Ignition and engine management systems
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment

b087f616 Additional operations on removal of the engine from a transmission
1. To disconnect a reception exhaust pipe from an exhaust system and to remove it from the car.
2. On cars with the catalyst to remove the heat-shielding screen.
3. To remove карданный a shaft.
4. To prop up a transmission by means of the corresponding lift and a wide board and a few to raise a transmission.
5. To unscrew four nuts of fastening of a beam of a box to the bottom of the car and the central bolt of fastening of a beam to a transmission. To remove a beam.
6. To lower a little a transmission and to disconnect a cable of a drive of a speedometer.
7. To disconnect a wire from the switch of lanterns of a backing.
8. On cars with system of injection of fuel to disconnect wires from the gauge of speed of the car which is located sideways transmissions.
9. To unscrew two bolts of fastening supporting скобы communications of a side scene with a transmission.
10. A corresponding punch to beat out a finger of fastening of a bar of a choice of transfers to a transmission.
11. To establish таль for lifting of the engine and to raise the engine. Length the sling and their arrangement should be such that at lifting of the power unit it hung at an angle 40–45 .
12. To unscrew скобы fastenings of the engine from the block of cylinders.
13. To check up that the steering wheel is established in movement position directly forward and a paint or a marker to note position of the bottom collar of an intermediate shaft and a gear wheel of steering transfer, then to disconnect an intermediate shaft from steering transfer.
14. To disconnect brake tubes from a forward part of a beam of a suspension bracket.
15. To prop up a beam by means of the corresponding lift and a wide board (without cleaning a jack from under a transmission), to unscrew bolts of fastening of a beam to the bottom of the car and to remove it.
16. To check up that all hoses and wires are disconnected from the engine and a transmission and to lower a jack supporting a transmission.
17. To lower the engine together with a transmission downwards and to take from under the car.