FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   - 3.2. Engine DOHC
      3.2.1. A technical characteristics
      + 3.2.2. The repair which is not demanding removal of the engine
      - 3.2.3. Removal and installation of the engine without a transmission
         3.2.3.1. Engine removal
         3.2.3.2. Additional operations on engine removal on cars with АКП
         3.2.3.3. Additional operations on removal of the engine from a transmission
         3.2.3.4. Engine installation
         3.2.3.5. Engine dismantling
         3.2.3.6. Cylinders
         3.2.3.7. Check and restoration of pistons and piston rings
         3.2.3.8. Piston fingers and rods
         3.2.3.9. A cranked shaft
         3.2.3.10. Radical and шатунные bearings
         3.2.3.11. A flywheel
         3.2.3.12. Engine assemblage
         3.2.3.13. Start of the engine after major repairs
      3.2.4. Ventilation system картера
      + 3.2.5. Greasing system
   + 3.3. Engine V6
   + 3.4. Ignition and engine management systems
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


b087f616

3.2.3.13. Start of the engine after major repairs
PERFORMANCE ORDER
1. After engine installation in the car to check up level of oil and cooling liquid.
2. To unscrew spark plugs, and to disconnect ignition system.
3. To turn the engine a starter while the lamp of emergency pressure of oil will not go out.
4. To screw in spark plugs, and to connect ignition system.
5. To start the engine and to check up tightness of all systems. Дымление the engine is the normal phenomenon as there is a burning out of oil got on a detail at engine assemblage.
6. Some time knock of hydraulic pushers of valves, before full filling with their oil will be audible.
7. To check up installation of a corner an advancing of ignition and idling turns.
8. After several minutes of work of the engine repeatedly to check up levels of oil and cooling liquid.
9. If on the engine new pistons, rings or loose leaves of a cranked shaft have been established, with the engine it is necessary to address, as c new and to make обкатку then to replace engine oil and the filter.