FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
- 7. Transmissions
   + 7.1. A mechanical five-speed transmission of type
   + 7.2. A mechanical transmission of type МТ 75
   - 7.3. Automatic transmission А4LD
      7.3.1. A technical characteristics
      - 7.3.2. Service and repair
         7.3.2.1. The work description
         7.3.2.2. Check of level of oil in a transmission
         7.3.2.3. Check and washing of a hydrokinetic transmission
         7.3.2.4. Check of pressure of oil in a transmission operating time
         7.3.2.5. Test of an overload of the engine by hydrokinetic transfer
         7.3.2.6. Adjustment of a tape of a brake of forward planetary transfer
         7.3.2.7. Removal and installation of a vacuum regulator
         7.3.2.8. The hydraulic booster of back planetary transfer
         7.3.2.9. A centrifugal regulator of pressure of oil
         7.3.2.10. Replacement of a back sealing ring
         7.3.2.11. Removal and installation of the mechanism of a choice of transfers
         7.3.2.12. Removal and installation of draught of a choice of transfers
         + 7.3.2.13. Adjustment of a cable of mechanism Kick-down
         7.3.2.14. Removal and transmission installation
         7.3.2.15. Malfunctions of an automatic transmission
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


b087f616

7.3.2.11. Removal and installation of the mechanism of a choice of transfers
PERFORMANCE ORDER
1. To remove a negative wire from the accumulator.
2. In car salon to remove the lever of a choice of transfers, an ashtray, to unscrew two screws of fastening of an overlay of the central console, to disconnect sockets and to remove an overlay.
3. To remove the heater switch in a back part of the central console and to unscrew two screws of fastening of an overlay of the console.
4. To remove an overlay of the console and to disconnect a socket from прикуривателя.
5. To unscrew two screws of fastening the consoles located under a compartment for cartridges, and two screws in the centre and a forward part of the console, to remove the central console and its arm.
6. To unscrew four bolts of fastening of the mechanism of a choice of transfers.
7. To raise the mechanism of a choice of transfers, to remove a spring clamp from draught of a choice of transfers and completely to remove the mechanism of a choice of transfers.
8. Installation is made in sequence, return to removal, thus it is necessary to establish a forward part of an overlay of the console under the central console, and bolts of fastening of an arm of the console to tighten only after console installation.