Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
- 7. Transmissions
+ 7.1. A mechanical five-speed transmission of type
+ 7.2. A mechanical transmission of type МТ 75
- 7.3. Automatic transmission А4LD
7.3.1. A technical characteristics
- 7.3.2. Service and repair
7.3.2.1. The work description
7.3.2.2. Check of level of oil in a transmission
7.3.2.3. Check and washing of a hydrokinetic transmission
7.3.2.4. Check of pressure of oil in a transmission operating time
7.3.2.5. Test of an overload of the engine by hydrokinetic transfer
7.3.2.6. Adjustment of a tape of a brake of forward planetary transfer
7.3.2.7. Removal and installation of a vacuum regulator
7.3.2.8. The hydraulic booster of back planetary transfer
7.3.2.9. A centrifugal regulator of pressure of oil
7.3.2.10. Replacement of a back sealing ring
7.3.2.11. Removal and installation of the mechanism of a choice of transfers
7.3.2.12. Removal and installation of draught of a choice of transfers
+ 7.3.2.13. Adjustment of a cable of mechanism Kick-down
7.3.2.14. Removal and transmission installation
7.3.2.15. Malfunctions of an automatic transmission
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment
|
The engine should be started only at positions of the lever of a gear change "Р" and "N". At the engine idling, installation of the lever of a gear change in one of positions "R", "D", "3", "2" or "1" should cause easy jerk of the car.
At increase in number of turns of the engine in position "D" or "R" and the pressed pedal of a brake or the tightened lever of a manual brake the engine should work with number of turns no more than 2000–2900 rpm. This test should not proceed more than 2 seconds. Pressure sizes at control number of turns also are idling resulted in corresponding (the tab. Control pressure of oil (кПа see)). |
|
