FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   - 3.2. Engine DOHC
      3.2.1. A technical characteristics
      - 3.2.2. The repair which is not demanding removal of the engine
         3.2.2.1. A chain газораспределительного the mechanism and asterisks
         - 3.2.2.2. A head of the block of cylinders
            3.2.2.2.1. Removal of a head of the block of cylinders
            3.2.2.2.2. Dismantling and assemblage of a head of the block of cylinders
            3.2.2.2.3. Check of a head of the block of cylinders
            3.2.2.2.4. Check of directing plugs of valves
            3.2.2.2.5. Processing of saddles of valves in a head of the block of cylinders
            3.2.2.2.6. Grinding in
            3.2.2.2.7. Assemblage of a head of the block of cylinders
            3.2.2.2.8. Installation of a head of the block of cylinders
         3.2.2.3. Removal and installation of a back sealing ring of a cranked shaft
      + 3.2.3. Removal and installation of the engine without a transmission
      3.2.4. Ventilation system картера
      + 3.2.5. Greasing system
   + 3.3. Engine V6
   + 3.4. Ignition and engine management systems
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


b087f616

3.2.2.2.3. Check of a head of the block of cylinders
PERFORMANCE ORDER
1. To check up planeness of a surface of a head of the block of cylinders interfaced to the block of cylinders by means of a steel ruler and a set measuring щупов. If неплоскостность 0,05 mm a head of the block of cylinders there are more is subject to replacement.
2. To check up a condition and diameter of bearings of camshafts. If diameter exceeds the limiting size, the head of the block of cylinders is subject to replacement.
3. To check up a condition of necks and cams of camshafts.
4. To check up a condition of working surfaces of hydraulic pushers of valves. At their considerable deterioration in an operating time at the top part of the engine there is a characteristic noise.
5. To check up a condition and diameter of nests under hydraulic pushers of valves. If diameter of nests exceeds the limiting size, the head of the block of cylinders is subject to replacement.