FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   - 3.2. Engine DOHC
      3.2.1. A technical characteristics
      - 3.2.2. The repair which is not demanding removal of the engine
         3.2.2.1. A chain газораспределительного the mechanism and asterisks
         - 3.2.2.2. A head of the block of cylinders
            3.2.2.2.1. Removal of a head of the block of cylinders
            3.2.2.2.2. Dismantling and assemblage of a head of the block of cylinders
            3.2.2.2.3. Check of a head of the block of cylinders
            3.2.2.2.4. Check of directing plugs of valves
            3.2.2.2.5. Processing of saddles of valves in a head of the block of cylinders
            3.2.2.2.6. Grinding in
            3.2.2.2.7. Assemblage of a head of the block of cylinders
            3.2.2.2.8. Installation of a head of the block of cylinders
         3.2.2.3. Removal and installation of a back sealing ring of a cranked shaft
      + 3.2.3. Removal and installation of the engine without a transmission
      3.2.4. Ventilation system картера
      + 3.2.5. Greasing system
   + 3.3. Engine V6
   + 3.4. Ignition and engine management systems
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


b087f616

3.2.2.2.2. Dismantling and assemblage of a head of the block of cylinders
THE GENERAL DATA

Head of the block of cylinders

1 – tubes of giving of oil to cams of camshafts,
2 – covers of bearings of camshafts,
3 – a camshaft operating inlet valves,
4 – a camshaft operating final valves,
5 – a head of the block of cylinders,
6 – asterisks of camshafts

PERFORMANCE ORDER
1. To arrange a head of the block of cylinders in forward and back parts on two wooden брусках.
2. To remove an inlet collector together with fuel system and a tube of tap of a cooling liquid (if have not been removed earlier).
3. To unscrew a thermal casing, and then a final collector.
4. To unscrew hairpins of fastening of both collectors.
5. To remove hydraulic pushers of valves and to place them in corresponding containers with oil for the further repeated installation on the places (if have not been removed earlier).
6. To compress in the order of a spring of valves the special adaptation and to take crackers of fastening of a persistent top plate of a spring. To remove the top plate and valve springs, paying attention to to damaging valve cores.
7. To take the valve from outside combustion chambers.
8. To remove маслоотражательные caps from directing plugs of valves.