FORD SCORPIO

1985-1994 of release

Repair and car operation


Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
- 14. An electric equipment
   14.1. A technical characteristics
   14.2. Safety locks and the relay
   14.3. Electronic blocks of management
   14.4. System of the central blocking
   14.5. System of indexes of turns
   14.6. The fuel computer
   14.7. Additional control system
   - 14.8. The generator
      14.8.1. Removal and generator installation
      14.8.2. Dismantling and generator assemblage
      14.8.3. Replacement of brushes of the generator and a pressure regulator
      14.8.4. The basic malfunctions of the generator
      14.8.5. Tension adjustment клинового a belt
   + 14.9. A starter
   + 14.10. A windscreen screen wiper, knot of indexes and a headlight
   14.11. Removal and installation of a combination of devices
   14.12. External and internal illumination
   + 14.13. An other electric equipment
   + 14.14. Electroschemes


b087f616

14.8.1. Removal and generator installation
THE GENERAL DATA

Generator fastening on two bolts

 1 – a small washer (can be absent),

2 – an arm of fastening of the generator,
3 – the generator,

4 – the big washer

Removal

PERFORMANCE ORDER
1. To disconnect a wire of weight from the accumulator, and also a socket of multicontact connection behind the generator (after removal of a safety fastener).
The prevention

The information in electronic memories is thus erased from memory.
2. To weaken bolts of fastening of the generator.
3. To turn the generator to the engine and to remove клиновой a belt from a generator pulley.
4. To unscrew bolts of fastening and to take the generator (1 – connection of wires, 2 – the bottom bolts of fastening).

Installation

PERFORMANCE ORDER
1. To insert the generator, to screw up bolts of its fastening and to tighten their hand.
2. To connect and fix a socket of multicontact connection of wires behind the generator.
3. To establish and pull клиновой a belt (1 – a bolt of the tension device, And = 10 mm – a belt deflection).
4. To tighten a bolt of adjustment of a tightness, then a forward bolt (arrow) of the bottom fastening and, at last, a back bolt (arrow) of the bottom fastening of the generator.
5. To connect a weight wire to the accumulator.
6. To check up a tension клинового a belt.
7. In case of need to weaken bolts of fastening of the generator, to pull клиновой a belt and again to tighten bolts, since a bolt of adjustment of a tightness, and then a bolt of forward and back fastening of the generator.