FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Fuel system
   5.1. A technical characteristics
   5.2. Fuel
   5.3. Neetilirovannyj gasoline of engines V6, 2.4 and 2.9 дм3
   + 5.4. System of giving of air
   + 5.5. Carburettor PIERBURG
   + 5.6. Carburettor WEBER 2V
   + 5.7. Carburettor WEBER 2V TLD
   - 5.8. System of injection of fuel
      5.8.1. Adjustment of turns of idling and quality of a mix
      5.8.2. Removal and installation of the gauge of position throttle заслонки
      5.8.3. Removal and installation of the valve of management by idling turns
      5.8.4. Removal and installation of measuring instruments of a stream of air
      5.8.5. Removal and installation of fuel atomizers
      5.8.6. Removal and installation of the temperature gauge of a fuel highway
      5.8.7. Removal and installation of a regulator of pressure of fuel
      5.8.8. Removal and installation of the case throttle заслонки on engine DOHC
      5.8.9. Removal and installation of the oxygen gauge (HEGO)
      5.8.10. Removal and installation of a coal adsorber
      5.8.11. Removal and installation of the electromagnetic valve of a coal adsorber
   5.9. Removal and installation of an inlet collector
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


b087f616

5.8.10. Removal and installation of a coal adsorber ENGINE DOHC 2,0 дм3 With the CATALYST

PERFORMANCE ORDER
Models till July, 1990
1. The coal adsorber settles down in a motor compartment on the right mudguard near to fastening of a rack of a suspension bracket.
2. To remove a wire of weight from the accumulator.
3. To unscrew 2 screws of fastening of a broad tank and to remove a tank from a coal adsorber.
4. Disconnect from top of a coal adsorber a vacuum hose.
5. To unscrew a fastening bolt, to take a coal adsorber from a motor compartment.
6. Installation is made in sequence, return to removal.
Models since July, 1990
7. The coal adsorber (it is specified by an arrow) settles down behind the right back wheel where it is established on the bottom party of a body of the car.
8. To lift a back part of the car and to fix on supports.
9. To remove a wire of weight from the accumulator.
10. To disconnect a vacuum hose from top of a coal adsorber and to unscrew the fastening screw.
11. To raise a coal adsorber, to unhook from adjusting скобы and to take from the car.
12. Installation is made in sequence, return to removal.