1985-1994 of release

Repair and car operation

Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Fuel system
   5.1. A technical characteristics
   5.2. Fuel
   5.3. Neetilirovannyj gasoline of engines V6, 2.4 and 2.9 дм3
   + 5.4. System of giving of air
   + 5.5. Carburettor PIERBURG
   + 5.6. Carburettor WEBER 2V
   - 5.7. Carburettor WEBER 2V TLD
      5.7.1. Removal and carburettor installation
      5.7.2. Adjustment of turns of idling and quality of a mix
      5.7.3. The needle valve поплавковой chambers
      5.7.4. The vacuum device of a drive throttle заслонки the secondary chamber
      5.7.5. Replacement of a diaphragm of the valve экономайзера
      5.7.6. The automatic starting arrangement
      5.7.7. Adjustment of turns of fast idling
      5.7.8. Removal and installation демпфера throttle заслонки
      5.7.9. Adjustment
   + 5.8. System of injection of fuel
   5.9. Removal and installation of an inlet collector
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


5.7.9. Adjustment
1. To adjust turns of idling and quality of a fuel mix.
2. To warm up the engine to working temperature and to remove the case of the air filter.
3. To take from демпфера throttle заслонки the plastic screen.
4. To disconnect a vacuum hose демпфера throttle заслонки and to connect демпфер by means of a tube to an inlet collector.
5. To start the engine and to measure turns. Engine turns should be more nominal and correspond to the value resulted in subsection 5.1.
6. If necessary to make adjustment. To remove a seal from the top part of the case демпфера throttle заслонки and, rotating the adjusting screw, to establish demanded turns.
7. To disconnect a tube from an inlet collector and to connect a vacuum hose демпфера throttle заслонки.
8. To establish the plastic screen and the case of the air filter.