FORD SCORPIO

1985-1994 of release

Repair and car operation


Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Fuel system
   5.1. A technical characteristics
   5.2. Fuel
   5.3. Neetilirovannyj gasoline of engines V6, 2.4 and 2.9 дм3
   + 5.4. System of giving of air
   + 5.5. Carburettor PIERBURG
   + 5.6. Carburettor WEBER 2V
   - 5.7. Carburettor WEBER 2V TLD
      5.7.1. Removal and carburettor installation
      5.7.2. Adjustment of turns of idling and quality of a mix
      5.7.3. The needle valve поплавковой chambers
      5.7.4. The vacuum device of a drive throttle заслонки the secondary chamber
      5.7.5. Replacement of a diaphragm of the valve экономайзера
      5.7.6. The automatic starting arrangement
      5.7.7. Adjustment of turns of fast idling
      5.7.8. Removal and installation демпфера throttle заслонки
      5.7.9. Adjustment
   + 5.8. System of injection of fuel
   5.9. Removal and installation of an inlet collector
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


b087f616

5.7.8. Removal and installation демпфера throttle заслонки
THE GENERAL DATA

Knot of a pusher of a throttle

1 – an entrance fuel branch pipe,
2 – air заслонка,
3 – the accelerating pump,
4 – the lever of a pusher of a diaphragm,
5 – a plastic cover,
6 – демпфер throttle заслонки,
7 – a vacuum diaphragm throttle заслонки the secondary chamber

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator and the case of the air filter.
2. To remove a vacuum hose демпфера.
3. To remove with демпфера throttle заслонки the plastic screen.
4. To unscrew two screws of fastening, to take an operating rod from a side scene throttle заслонки and to take assemblage from the carburettor.
5. To unscrew four screws of fastening, to uncover diaphragms and to take a spring.
6. To take from the case a diaphragm.
7. To clear interfaced surfaces of the case and a diaphragm cover.
8. To establish in the case a diaphragm, a spring, a cover and to screw screws of fastening of a cover.
9. The further assemblage is made in sequence, return dismantling, but before installation of the plastic screen to check up adjustment демпфера throttle заслонки.