FORD SCORPIO

1985-1994 of release

Repair and car operation

8.3.6. Adjustment of gear wheels of the main transfer

THE GENERAL DATA

Measurement of an axial backlash between semiaxial gear wheels and a differential box


Measurement of the moment of resistance of rotation of a gear wheel of the main transfer by means of a dynamometer 15.041 and plugs 15.073

PERFORMANCE ORDER

1. To establish flanges (fig. of the Detail of the back bridge see) adjustments of a backlash of bearings of a box of differential without linings of round section. 2. To establish the oiled bearings of a box of differential, and also replacing box of differential. 3. To screw up a hand flanges of adjustment of a backlash of bearings of a box of differential before their contact to bearings and to tighten накатанную a nut of fixing of a replacing box. 4. To turn repeatedly replacing box for exact packing of rollers of bearings. 5. To establish the indicator of hour type on картере, and its measuring tip to rest against the middle of a replacing box. 6. To execute one complete revolution of a replacing box and to observe of fluctuations of an arrow of the indicator. 7. To establish replacing box in position in which the arrow of the indicator costs on the average position between extreme indications. Replacing box not to rotate any more. 8. To establish the indicator of hour type on the holder (the adaptation 15.008). To rest its measuring tip against a template of the adaptation 15.075 and to adjust the indicator. For the bridge 7,5 "to use the bottom plane of a template, and for the bridge 7" – the top plane. 9. To rest the holder of the indicator against an end face of a gear wheel of the main transfer, and a measuring tip of the indicator – in the middle of a replacing box. 10. To remove a difference concerning the distance established according to a template. 11. To correct the measured distance, selecting a thickness of a lining between the internal bearing of a leading gear wheel and a gear wheel of the main transfer so that the deviation from the zero indication of the indicator made no more than 0,01 mm. 12. After a tightening of a nut of fastening of bearings of its gear wheels follows зачеканить. 13. By means of the adaptation 15.047 And to establish a new sealing ring of a gear wheel of the main transfer. 14. To establish a flange of a gear wheel of the main transfer (for connection with the back hinge карданного a shaft) and to tighten a nut of fastening of a flange the corresponding moment.