1985-1994 of release
Repair and car operation
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
- 6. Coupling
6.1. A technical characteristics
- 6.2. Service and repair
6.2.1. Coupling removal
6.2.2. Coupling check
6.2.3. Coupling installation
6.2.4. Replacement of the needle bearing of a shaft of coupling
6.2.5. Replacement of a cable of coupling
6.2.6. The mechanism of a pedal of coupling
6.2.7. Replacement of a pedal of coupling
6.2.8. Removal and installation выжимного the bearing
6.2.9. Free wheeling adjustment
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment
The clamp of the automatic mechanism can be blocked on gear sector of a pedal of coupling, especially in the presence of considerable deterioration. There will be no in this case a cable free wheeling that will lead to proslipping of coupling and considerably will accelerate deterioration of overlays. For mechanism check it is necessary to open a cowl and sharply to extend a cover of a cable from a partition that will lead to a tension of a cable and поворачиванию a gear segment. At normal work of the mechanism clicks from a latch moving on a gear segment are audible, and at отпускании covers of a cable the mechanism occupies a starting position. In case of latch jamming to extend a cover of a cable from a partition it is impossible.
If there was a jamming, to remove a coupling cable is problematic.
The first variant of removal of a cable: to make effort the switching off lever for a cable detachment.
With the second – to cut a cable, however it is necessary to remember that the switching off lever will come back at once back.
Вытягивание a cable from a forward partition sometimes leads to jamming elimination, however it is desirable to replace the mechanism with the new in this case.