FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Fuel system
   5.1. A technical characteristics
   5.2. Fuel
   5.3. Neetilirovannyj gasoline of engines V6, 2.4 and 2.9 дм3
   + 5.4. System of giving of air
   + 5.5. Carburettor PIERBURG
   - 5.6. Carburettor WEBER 2V
      5.6.1. Adjustment of turns of idling and quality of a mix
      5.6.2. Removal and carburettor installation
      5.6.3. Assemblage and carburettor adjustment
      5.6.4. Adjustment of a backlash air заслонки
      5.6.5. Adjustment of a backlash of an intermediate step
   + 5.7. Carburettor WEBER 2V TLD
   + 5.8. System of injection of fuel
   5.9. Removal and installation of an inlet collector
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


b087f616

5.6.2. Removal and carburettor installation
PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove the case of the air filter.
3. To disconnect заслонку and wires of the step-by-step engine. For a detachment of a socket of the step-by-step engine it is necessary to wring out a lock clip (it is specified by an arrow).
4. To disconnect an arm of a throttle from the lever of a drive throttle заслонки.
5. To remove a hose of giving of fuel in the carburettor. At presence on hoses of coupling collars to bite off them and instead of them to establish the collars clamped by the screw.
6. To disconnect from the carburettor vacuum tubes.
7. To unscrew four nuts of fastening of the carburettor to an inlet collector.
8. To remove the carburettor and to close an aperture in an inlet collector pure rags.
9. Carburettor installation is made in sequence, return to removal. After installation to adjust the maintenance WITH.
10. To remove the carburettor from the engine.
11. Carefully to clear the carburettor outside.
12. To unscrew four screws and to remove the step-by-step engine.
13. To unscrew 6 screws of fastening of the top cover of the carburettor, to uncover and a lining.
14. To unscrew the big brass nut located behind a fuel tube and to remove the fuel filter.
15. To take a float axis. To remove a float and the needle valve.
16. To unscrew three screws and to remove the case of a bimetallic spring, preliminary having noted position of the case concerning the carburettor.
17. To unscrew three screws and to remove the case заслонки, having noted position of the case concerning the carburettor.
18. To unscrew jets from the carburettor case.
19. To unscrew primary and secondary эмульсионные tubes, having remembered their position.
20. To unscrew four screws and to uncover the accelerating pump. To remove a diaphragm and a spring.
21. To unscrew screws of fastening of vacuum knot secondary throttle заслонки. To disconnect a rod of a side scene and to remove knot.
22. To uncover the capacity valve, a spring and a diaphragm.

23. To clear поплавковую the chamber. To blow compressed air all jets and to clear their saddles.