FORD SCORPIO

1985-1994 of release

Repair and car operation


Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   + 3.2. Engine DOHC
   + 3.3. Engine V6
   + 3.4. Ignition and engine management systems
   - 3.5. Diesel engines
      3.5.1. A technical characteristics
      3.5.2. The repair which is not demanding removal of the engine
      3.5.3. Check and adjustment of backlashes of valves
      + 3.5.4. Fuel system
      + 3.5.5. A head of the block of cylinders
      3.5.6. Removal and engine installation
      + 3.5.7. Dismantling, repair and engine assemblage
      3.5.8. Турбокомпрессор
      + 3.5.9. Greasing system
      + 3.5.10. Cooling system
      3.5.11. Typical malfunctions of the engine
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


b087f616

3.5.3. Check and adjustment of backlashes of valves
THE GENERAL DATA

Arrangement of valves

The backlash of valves should be checked and, in case of need, to regulate on the cold engine after its finding in the switched off condition about four hours. It is recommended to carry out these procedures each 20 000 km of run of the car, however, not less often, than time in two years.

PERFORMANCE ORDER
1. To disconnect a wire of weight from the accumulator.
2. On engines with a turbo-supercharging to weaken collars and to disconnect an inlet air hose from турбокомпрессора.
3. To remove the air filter.
4. To uncover heads of the block of cylinders.
The prevention

From the end of 1987 the lining of a cover of a head of the block of cylinders of reusable use is established.
5. To adjust a backlash of valves (the tab. Sequence of adjustment of a backlash of valves) after turn of a cranked shaft see so that final the valve were one after another as much as possible open.
The prevention

Working backlash of valves on the cold engine: the engine without pressurisation: the inlet valve – 0,30–0,35 mm; the final valve – 0,30–0,35 mm; the engine with a turbo-supercharging: the inlet valve – 0,10–0,20 mm; the final valve – 0,20–0,30 mm.
6. For adjustment of a backlash of the valve it is necessary to weaken a counternut of a regulating bolt of the corresponding lever of the valve, holding with a screw-driver an adjusting bolt, and then to turn an adjusting bolt while the plate щупа will densely not enter a corresponding thickness between the end of the lever and a head of a core of the valve. In this position it is necessary to tighten a counternut of an adjusting bolt, holding this bolt with a screw-driver.
7. To establish a cover of a head of the block of cylinders and the air filter.
8. To connect to the accumulator a weight wire.

Sequence of adjustment of a backlash of valves

The maximum opening of the final valve
Adjustment of a backlash of the inlet valve
Adjustment of a backlash of the final valve
1st cylinder
3rd cylinder
4th cylinder
3rd cylinder
4th cylinder
2nd cylinder
4th cylinder
2nd cylinder
1st cylinder
2nd cylinder
1st cylinder
3rd cylinder
The prevention

The first cylinder is from outside a flywheel.