1985-1994 of release

Repair and car operation

Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   + 3.2. Engine DOHC
   + 3.3. Engine V6
   - 3.4. Ignition and engine management systems
      3.4.1. A technical characteristics
      - 3.4.2. Ignition and engine management systems System of ignition ESC II System of ignition ЕЕС IV The ignition distributor Check of a corner of installation of an advancing of ignition The ignition block (models with system of injection of fuel) The ignition coil A fuel trap on engines with the carburettor The engine management block The step-by-step engine of the carburettor The device of heating of an inlet collector of engines with the carburettor The relay of a control system of the engine Installation of a corner of an advancing of ignition and idling turns The gauge of turns and position of a cranked shaft The gauge of temperature of air The gauge of temperature of fuel The gauge of speed of the car The gauge of absolute pressure in a collector (MAP)
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment

b087f616 The ignition coil

The ignition coil

1 – the coil of ignition,

2 – the screw of fastening,

3 – a high-voltage wire

The ignition coil is established on the left forward party of a motor compartment and fastens two screws.

To disconnect from the coil of ignition of a wire and an ohmmeter to check up resistance of windings.

For check of a primary winding of the coil of ignition the ohmmeter for measurement of small resistance as the usual device can not distinguish resistance of a winding from short circuit is required.