FORD SCORPIO

1985-1994 of release

Repair and car operation


Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   + 3.2. Engine DOHC
   + 3.3. Engine V6
   - 3.4. Ignition and engine management systems
      3.4.1. A technical characteristics
      - 3.4.2. Ignition and engine management systems
         3.4.2.1. System of ignition ESC II
         3.4.2.2. System of ignition ЕЕС IV
         3.4.2.3. The ignition distributor
         3.4.2.4. Check of a corner of installation of an advancing of ignition
         3.4.2.5. The ignition block (models with system of injection of fuel)
         3.4.2.6. The ignition coil
         3.4.2.7. A fuel trap on engines with the carburettor
         3.4.2.8. The engine management block
         3.4.2.9. The step-by-step engine of the carburettor
         3.4.2.10. The device of heating of an inlet collector of engines with the carburettor
         3.4.2.11. The relay of a control system of the engine
         3.4.2.12. Installation of a corner of an advancing of ignition and idling turns
         3.4.2.13. The gauge of turns and position of a cranked shaft
         3.4.2.14. The gauge of temperature of air
         3.4.2.15. The gauge of temperature of fuel
         3.4.2.16. The gauge of speed of the car
         3.4.2.17. The gauge of absolute pressure in a collector (MAP)
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


b087f616

3.4.2.8. The engine management block
THE GENERAL DATA
The prevention

Since January 1987 on the engine 1,8 дм3 hybrid block ESC of II new design of the smaller size is established.

The block of engine management established since January 1987 on engine 1,8 дм3

Removal of a socket from block EES IV

 1 – многовыводной a socket,

2 – a bolt of fastening of a socket,

3 – block EES IV

BLOCK ESC II, ENGINES WITH THE CARBURETTOR

PERFORMANCE ORDER
1. To remove a negative wire from the accumulator.
2. To disconnect a vacuum pipe (it is specified by an arrow) from the block.
3. To wring out скобу blockings and to remove a socket.
4. To unscrew three screws and to remove block ESC II.

BLOCK ESC II, ENGINES WITH SYSTEM OF INJECTION OF FUEL

On engines DOHC and V6 2,4 and 2,9 дм3 the block is located from the passenger party and is accessible from below a ware box.

PERFORMANCE ORDER
Engines OHC and V6 2,8 дм3
1. To remove a negative wire from the accumulator.
2. To remove furnish under the panel of devices on the passenger party.
3. To disconnect the block and to lower it on a salon floor.
4. To remove a socket from the block.
Engines DOHC and V6 2,4 and 2,9 дм3
5. To disconnect a negative wire from the accumulator.
6. To take the block from an installation suspension bracket.
7. To unscrew a bolt of fastening of a socket and to remove a socket.