FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
- 10. Suspension brackets
   - 10.1. A forward suspension bracket
      10.1.1. A technical characteristics
      - 10.1.2. Service and repair
         10.1.2.1. A beam of a forward suspension bracket
         10.1.2.2. Removal and installation of a rack of a forward suspension bracket
         10.1.2.3. Dismantling and assemblage of a rack of a suspension bracket
         10.1.2.4. Removal and stabilizer installation
         10.1.2.5. Replacement металлорезиновой lever plugs
         10.1.2.6. Removal and installation of a rotary fist
         10.1.2.7. Installation of forward wheels
         10.1.2.8. Replacement of bearings of a nave of a wheel
   + 10.2. A back suspension bracket
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


b087f616

10.1.2.1. A beam of a forward suspension bracket

Removal

PERFORMANCE ORDER
1. To weaken nuts of fastening of a wheel from the corresponding party of the car.
2. To lift and fix a forward part of the car and to remove forward wheels.
3. By means of a jack to prop up the hinge of the cross-section lever.
4. To unscrew bolts of fastening of a rack of a suspension bracket to a rotary fist of a wheel.
5. Into cut of a rotary fist to insert the adaptation 14.026 and to turn it on 90 °, weakening the bottom fastening of a rack of a suspension bracket.
6. To press downwards a rotary fist, the suspension bracket rack will not be released yet, paying attention not to damage a brake hose.
7. To suspend a rotary fist to a body so that it did not concern brake hoses.
8. In a motor compartment to unscrew three nuts (are specified by arrows) fastenings of a rack of a suspension bracket.
9. To take in a direction downwards a suspension bracket rack.

Installation

PERFORMANCE ORDER
1. To establish a suspension bracket rack on a corresponding place.
2. To check up a centering of a rod of the shock-absorber concerning a body and to screw up three nuts of the top fastening.
3. To insert the adaptation 14.026 into a groove of a rotary fist and to turn it on 90 °.
4. To establish the bottom part of a rack in a rotary fist.
5. To remove the adaptation 14.026.
6. To screw up a bolt of fastening of a rack to a rotary fist of a wheel and to tighten the corresponding moment.
7. To screw wheels, to lower the car and to tighten nuts of wheels the corresponding moment.
8. To check up a convergence of forward wheels.