FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
- 9. A steering
   9.1. A technical characteristics
   + 9.2. Service and repair
   - 9.3. A steering with the hydraulic booster
      9.3.1. A technical characteristics
      - 9.3.2. Service and repair
         9.3.2.1. Removal and installation of steering transfer
         9.3.2.2. Dismantling and assemblage of steering transfer CAM GEAR
         9.3.2.3. Dismantling and assemblage of steering transfer ZF
         9.3.2.4. Removal and installation of a steering column
         9.3.2.5. Dismantling and assemblage of a steering column
         9.3.2.6. Removal and installation of the pump of the amplifier of a steering
         9.3.2.7. Dismantling and assemblage of the pump of the hydraulic booster
         9.3.2.8. Replacement and tension adjustment приводного a belt
         9.3.2.9. Replacement of protective covers of the steering mechanism
         9.3.2.10. Removal of air from system of a steering with the hydraulic booster
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


b087f616

9.3.2.8. Replacement and tension adjustment приводного a belt
PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. On cars with the conditioner to remove приводной a compressor belt.
3. On cars with engines OHC to weaken bolts of an adjusting lath of a tension of a belt of the generator.
4. On cars with engines V6 to weaken a bolt of fastening and a bolt on an adjusting lath of the pump. To turn the pump to the engine and to remove приводной a belt.
5. To check up a condition приводного a belt on presence of cracks, stratifications and other mechanical damages and if necessary to replace. In case two are established приводных a belt, both belts even if one of belts is in a good condition are subject to replacement.
6. Adjustment of a tension of a belt is made by turn of the generator or the pump from the engine and its fixing in this position by a tightening of bolts on an adjusting lath. The belt tension should be such that by pressing a belt with moderate effort the belt deflection made 10 mm.