FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
- 13. A body
   13.1. Care of a body
   + 13.2. A cowl
   + 13.3. Doors
   + 13.4. External elements of a body
   + 13.5. Salon elements
   - 13.6. Heating and ventilation system
      13.6.1. Removal and installation of the block of management by a heater
      13.6.2. Removal and installation of cables of management of a heater
      13.6.3. Removal and heater installation
      13.6.4. Dismantling and heater assemblage
      13.6.5. Removal and installation of air lines of a heater
   + 13.7. The conditioner
+ 14. An electric equipment


b087f616

13.6.2. Removal and installation of cables of management of a heater

FORWARD CABLES

PERFORMANCE ORDER
1. To remove the block of management of a heater.
2. To remove the central console.
3. To remove скобу consoles and an internal casing of the lever of a gear change.
4. To remove a covering under the forward panel from two parties.
5. To uncover a ware box.
6. To remove a radio receiver.
7. To remove modules AVS and ЕЕС IV.
8. To remove the bottom covering from outside the passenger for access to the heater case.
9. To unscrew two screws of fastening and to remove cables from a heater.
10. Installation is made in sequence, return to removal.

BACK CABLES

PERFORMANCE ORDER
1. To remove the central console.
2. To remove a forward seat from the corresponding party.
3. To remove a pillow of a back seat.
4. To unscrew a bolt of the bottom fastening of a forward belt.
5. To remove forward fastening of a sealant of a door, having unscrewed three screws.
6. To unscrew the forward screw of fastening of a sealant of a back door.
7. To turn away a forward rug from fastening for providing of access to a heater cable.
8. To release a cable and to disconnect it from the block of management of the lever заслонки.
9. Installation is made in sequence, return to removal.